NXP Semiconductors BLDC - Freedom Development Platform

Hardware setup
BLDC Control Demo User's Guide, Rev. 6, 06/2020
NXP Semiconductors 9
• Connect the power input cable (3-wire connector) of the Linix motor to its corresponding
connector (J5) on the TWR-MC-LV3PH motor control driver board.
• Plug in the power supply cable that is attached to the TWR-MC-LV3PH system kit to the
motor control peripheral board TWR-MC-LV3PH.
• Connect the TWR MCU module to the host PC via a USB cable.
Figure 7. Assembled Tower System
4.5.
Freedom development platform
To run the BLDC application using Freedom, you need these Freedom boards:
• Kinetis KV11Z Freedom board (see FRDM-KV11Z), Kinetis KV31F Freedom board
(see FRDM-KV31F), Kinetis KE15Z, or Kinetis KE16Z Freedom board.
• 3-Phase Low-Voltage Power Freedom shield (see FRDM-MC-LVBLDC) including the
Linix motor.