NXP Semiconductors BLDC - Instructions; Running the Motor; Stopping the Motor; Clearing a Fault

Acronyms and abbreviations
BLDC Control Demo User's Guide, Rev. 6, 06/2020
NXP Semiconductors 21
• In case of a fault, click on the fault notification to clear the fault.
• Click the “Demo Mode” button to turn the demonstration mode on/off.
• Click the “STOP” button to stop the motor.
7. Instructions
7.1.
Running the motor
1. Assemble your NXP motor control hardware
2. Download the correct project into your target using the OpenSDA debug interface.
3. Open the FreeMASTER project, establish the communication between MCU and PC
4. Set up the required speed of the motor on the speed slider on the FreeMASTER control page.
7.2.
Stopping the motor
1. Click on the Stop button on the FreeMASTER control page.
2. Require zero speed with using speed slider.
3. In emergency cases, turn off power supply.
7.3.
Clearing a fault
To clear a fault click on the CLEAR FAULT button on the control page.
7.4.
Turning on demonstration mode
1. If you use the FreeMASTER control page, click the “Demo” button.
4. If you do not use the FreeMASTER control page push the corresponding button on your
development board to turn demonstration mode on/off.
8. Acronyms and abbreviations
Table 13. Acronyms and abbreviations
Term Meaning
AN Application Note
BLDC Brushless DC motor
DRM Design Reference Manual
MCU Microcontroller
MSD Mass Storage Device