- 16 -
13. ATTENTION
NOTE: Installation should always include all the accessories necessary to ensure operation in accordance with current laws and standards,
utilising always and only original O&O parts.
Always follow the manufacturer’s instructions for using and installing this equipment as he cannot be considered liable for any damages
or injury arising from an improper or unreasonable use.
O&O srl declines all responsibility for any inaccuracies contained in this leaet and reserves the right to make alterations at any time
without prior notice.
12. TROUBLESHOOTING GUIDE
1) The chain drops by a few centimetres at the end of the close cycle.
At the end of the rst close cycle, the control unit determines the force necessary to be applied with the electronic brake and the
excessive dip will be compensated when subsequent close cycles are performed.
2) The barrier is reopened by the automation system during a close cycle, even though there are no obstacles and the photocell beams
are not interrupted.
The chain height setting is too high. Reduce the setting with trimmer PM2.
11. WORKING WITH A BUFFER BATTERY
KIT-BATT-SC allows the automation system to operate even when the mains power supply is disconnected for a short time.
Consult the KIT-BATT-SC installation manual.
To Next Page
Loading...
Need help?
General
