Oase BioCompact 25 - BioCompact 50 Assembly Guide; Installation and Connection; Unit Installation and Cable Routing

‐EN‐
12 BioCompact 25/50
5.
Filltheemptychamberofthefilterboxwith
filtermedium.
Push the suction cups into the mounting
holesofthefiltercontainerwithatwisting
movement.
6. Reassembletheunitinthereverseorder.
7. Adjusttheflowattheflowregulator.
– Toreducetheflow:Movetheflow
regula‐torinthedirectionMin.
– Toincreasetheflow:Movetheflow
regu‐latorinthedirectionMax.
8. Fitthewaterdistributor.
1. Removethelidofthefiltercontainer.
2. Pulloutthefoamholder.
3. Pulloutthefilterbox.
4.
B
BioCompact 50
How to proceed:

waterlevelintheaquarium.
C
 Fasten the device, e.g. to the wall of the
aquarium.
 Routethepowerconnectioncablesuchthat
itformsadriploop!
 Switchingon:Connecttheunittothemains.
Theunitswitchesonimmediately.
 Switchingoff: Disconnect the unit fromthe
mains.
INSTALLATIONANDCONNECTION
NOTE
Ensurethatthepumpneverrunsdry!
Possibleconsequences:Thepumpwillbe
destroyed.
Protective measure: Regularly check the