4
- English -
Installation and connection
Operation with pool water or salt water
● For operation with pool water or salt water, the following limits must be adhered to:
Solo operation
● Only install the unit in the permitted positions to ensure fault-
free operation.
● Take the required distances into consideration. (See Distances
to be adhered to)
● Use suitable fastening material for the type of ground. Ensure
that the fastening means securely hold the unit. Take
the weight of the unit into consideration. (See Technical data)
● Fit a slide valve in the water supply upstream of the inlet of the
unit if the unit is to be installed below the water level. This allows
the water supply to be shut off for maintenance work.
Distances to be adhered to
● Swimming pond or pool that may be accessed by people
○ Install the unit at least 6.6 ft (2 m) away from the water.
● Garden pond or aquarium:
○ Install the unit at least 6.6 ft (2 m) away from the water.
● Allow sufcient space for carrying out maintenance work:
○ Ensure that there is space of at least double the width of the casing for removing the unit head.
Type Pool water Salt water
pH value 7.2 … 7.6 7.5 … 8.5
Free chlorine 0.04 … 0.08 moz/gal (0.3 … 0.6 mg/l) < 0.04 moz/gal (< 0.3 mg/l)
Bound chlorine < 0.0267 moz/gal (< 0.2 mg/l) -
Chloride content < 26.7 moz/gal (< 200 mg/l) -
Salt content - < 3.5 %
Water temperature 39° F - 86° F (+4° C - +30° C) 39° F - 77° F (+4° C - +25° C)
● Pool water or salt water can impair the appearance of the unit. Such impairments are excluded from the guarantee
BTN0037
BTN0020
BTN0037
BTN0022
BTN0040
BTN0041
To Next Page
Loading...
Need help?
General
