5
4
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
Connecting the inlet
Installation and connection
Important:
● Use hoses that are suitable for a pressure of at least
14.5 psi (1 bar).
1. Push the inlet nozzle into the inlet.
○ The inlet nozzle is only necessary for a ow rate <
2.642 gal/h (10.000 l/h to ensure unimpaired rotation
of the cleaning rotor.
2. Screw the hose connector with union nut and seal onto
the inlet.
3. Connect the hose with the stepped hose adapter and
secure with a hose clip
Connecting the outlet
1. Screw the stepped hose adapter with union nut
and seal onto the adapter
2. Connect the hose with the stepped hose adapter
and secure with a hose clip
3. Screw the cover cap with at seal onto the outlet.
○ The cover cap has to close the outlet opposite
the inlet so that the main ow of water is
guided along the UVC lamps and is exposed to
the UV radiation for as long as possible
Connect the unit to the ow-through lter
● Take the required distances into consideration. (See Distances to be adhered to)
● Fit a slide valve in the water supply upstream of the inlet of the unit if the unit is to be installed below the water level.
This allows the water supply to be shut off for maintenance work.
BTN0020
BTN0037
BTN0022
BTN0040
BTN0041
To Next Page
Loading...
