6
BioSmart
This section describes the connection of the UVC clarifying unit Bitron with a pump fed system.
● Please adhere to the instructions for use of the ow-through lter.
1. Insert the outlets with at seals through the holes in the container wall.
2. Fitting the inlet: Screw the inlet nozzles with the O rings onto the outlets and hand tighten.
3. Closing the bypass (optional): Screw the cover cap onto the outlet instead of the inlet nozzle.
4. Connect the Bitron to the lter pump. (See Connecting the inlet)
BioTec ScreenMatic
● Please adhere to the instructions for use of the ow-through lter.
1. Insert the outlets with at seals through the holes in the container wall into the distributor.
2. Screw the distributor nuts with the O rings onto the outlets and hand tighten.
3. Connect the Bitron to the lter pump. (See Connecting the inlet).
BTN0020
BTN0037
BTN0022
BTN0040
BTN0041
To Next Page
Loading...
