EN
43
Positioning the filter cover
Ensure that the O-ring on the container is positioned correctly on the container rim.
– Moisten the seal with water or grease the seal, if necessary, so that the filter head is easier
to push onto the container.
Evenly and forcefully push the filter cover as far as possible onto the container.
– The filter ring must make full contact with the container, otherwise the clamping ring will
not close.
Fasten the filter cover with the clamping ring and close the locking latch.
– The locking latch prevents the clamping ring from coming loose accidentally, which would
cause pond water to leak in an uncontrolled manner.
– Use flat nose pliers if the locking latch is hard to move.
Attach all hoses (screw hose connectors in place).
To Next Page
Loading...
Need help?
General
