8
CLEANING AND MAINTENANCE
Draining the Reservoirs
1. Turn o the hot water switch on the back of the cooler.
2. Dispense water out of the hot water icon until the temperature drops to a safe level to avoid the risk of
scalding (approximately 2L).
3. Shut o the water supply to the cooler.
4. Press the cold water icon to depressurize the system.
5. Unplug the cooler. Disconnect the water inlet line to the cooler.
6. Place a container beneath the cold water drain on the back of the cooler.
7. Remove the cold water drain cap and drain the tank until water no longer comes out. Re-install the cold
water drain cap.
8. The hot water drain is located on the bottom of the cooler near the back. Place a container underneath it.
9. Remove the hot water drain cap and drain the tank until water no longer comes out. Re-install the hot
water drain cap.
QUICK CONNECT FITTING INSTRUCTIONS
COLLET
BODY
To connect, push tube through
collet ring into body.
Tube must sit fully past o-ring. To disconnect, push collet ring
against body and pull tube out.
To Next Page
