B: Connecting the water line
Section 3: Installation
For the single “Versafiller ready” cooler, the tube to connect to the Versafiller
is found inside the access panel (the compressor compartment). This tube
supplies cold water from the cooling tank to the Versafiller.
¼” OD tube to connect
to Versafiller
Note: If you are retrofitting the Versafiller to an existing cooler,
follow the instructions starting on the next page.
For split level “Versafiller ready” coolers, the tube to plumb in the
Versafiller is packaged in the dummy unit.
Remove tube from bag.
First, remove plug from
fitting on tank drain
Next, insert end of
tube into fitting.
To Next Page
Loading...
Need help?
General
