Oasis PG8ACSL User Manual

2. Remove tar tape from
the insulation on the
outlet tube.
Remove tar tape
3. Pull back insulation and cut
the copper tube with a
tubing cutter. Cut where
there is at least 1 inch of
straight tubing on each side
of the cut.
4. Install TEE fitting by
connecting the copper
tubing to each end. Then
install the 32” piece of
plastic tubing to the TEE
branch.
32” plastic
tubing
(supplied)
Section 3: Installation: For the P8AM Version: Versacooler I

Oasis PG8ACSL Specifications

General

Brand	Oasis
Model	PG8ACSL
Category	Water Dispenser
Language	English