Oce TDS750 - View Files on the Océ TDS750 Power Logic Controller; View Locally Scanned Files

View files on the Océ TDS750 Power Logic
®
Controller
View locally scanned files
Introduction
You can automatically view a file after scanning or you can view a locally stored scanned
file. You can configure the settings in such a way that the scanned file is opened automat-
ically.
Purpose
Check the quality of the scanned file before you print or archive the scanned file.
Note:
It is not possible to view scanned files that are stored at a remote location.
You cannot use Océ TDS750 Power Logic Controller Remote to view scanned files.
How to view a file automatically after scanning
1.
Open the Océ TDS750 Power Logic
®
Controller application.
2.
Open the 'System' menu and select Autoview.
Result
When you scan to file the next time, the viewing screen will start up a secondary window
and show the scanned file. If the Autoview function is not enabled, you can use the view
button in the Océ TDS750 Power Logic
®
Controller application to open the secondary
window manually. The procedure below describes this action in detail.
How to view a locally stored scanned file
1.
Access the Océ TDS750 Power Logic
®
Controller application.
2.
Click 'Scan jobs' in the vertical icon toolbar on the left-hand side of the screen.
3.
Select a local destination.
4.
Select a scanned file in the right-hand section of the workspace.
Chapter 5 - The Océ TDS750 Power Logic
®
Controller application
261
View locally scanned files