10 | Cobalt Temperature Monitor Installation
Recommended order for installing modules
In addition to placing your Cobalt 2 module as described above for best
wireless performance, you may also optimize overall network
performance by proceeding with installation as follows:
1. Examine the general layout of your site to determine the
placement of your Cobalt 2 modules. The extent of your pre-
installation site survey depends on the number of modules to
install. Feel free to contact your sales representative for more
information on this topic.
2. Place all modules in their final locations before running wireless
setup (described below in Activation and automatic wireless
configuration, on pg. 12).
3. Begin activation by pressing on the module’s button for three
seconds (long-press), starting with the modules closest to your
receiver, working your way “out” in concentric circles. This
enables each Cobalt 2 module to establish the optimal
connection to your receiver.
Figure 3 – Start installation with modules closest to your
receiver and work your way “out” in concentric circles.
To Next Page
Loading...