6 | Cobalt Temperature Monitor Installation
Introduction
Congratulations and thank you for choosing the Oceasoft Cobalt 2
wireless temperature monitor. This document covers Cobalt 2 modules
with either internal or external probes.
This Installation Guide describes how to get your new Cobalt 2 module
up and running. Detailed configuration instructions and software settings
are provided in the complete Cobalt 2 User Guide provided with your
product.
Pre-requisites
For the purposes of this Installation guide, we assume that:
ThermoClient/ThermoServer software is installed and
configured on your computer, and that you have appropriate
access rights to configure devices.
A Cobalt receiver is installed on your computer or network.
Please see the relevant product manuals for details on installing Cobalt
receivers and ThermoServer/ThermoClient software.
Package contents
Cobalt 2 wireless monitoring module with battery
Internal or external temperature probe
o Digital Temperature Internal Modules (+10° to +50°C)
Ambient temperature measurement
o Digital Temperature External Modules (-40° to +80°C)
Freezers, refrigerators, and cold rooms
o Digital Temperature External Modules (-40° to +120°C)
Ovens, incubators, and water baths
Cobalt mounting kit with plastic holder, magnet, screws and
Velcro
®
For modules with external probe only:
o Flat cable (-40°C to +80°C)
o Sensor mounting kit with 2 wire-ties and 4 plastic
holders with adhesive backing
To Next Page
Loading...