Ocea Soft Cobalt 2 - Placing external probe and Cobalt 2 module

Installation procedure | 11
Placing external probe and Cobalt 2 module
1. If you have a Cobalt 2 module with an external probe, run the
temperature probe into the enclosure via the door joint, taking
care to place the flat cable flush with the joint.
2. Clean the surface for the probe using alcohol to remove any
grease or dirt.
3. Attach one of the plastic cable holders to the probe, remove the
protective strip from the adhesive, and place the holder on the
clean spot inside the enclosure.
4. Place the probe/capillary cable connector on the inside the
enclosure in the same manner, as shown here:
Figure 4 – Probe inside refrigerator enclosure (modules with
external probe only )
5. Your mounting kit includes a plastic holder that can be mounted
using the provided magnet, screws or Velcro
®
. Choose the
method that is most appropriate for your situation and place the
Cobalt 2 module as described earlier in Placing your Cobalt 2
module for best performance (pg. 9), for example:
Figure 5 – Cobalt 2 mounted on refrigerator door
6. Attach or coil excess cable neatly.