Ocea Soft Cobalt 2 - Software configuration; Testing the connection

Software configuration | 13
Software configuration
When activating your Cobalt 2 module as described above, the device
adds itself to your current ThermoServer/ThermoClient configuration.
Testing the connection
Check wireless signal strength
You may use ThermoClient to test the wireless signal strength as
described here, entering your login name and password when prompted
by the software.
1. Launch ThermoClient on your computer and enter your login
name and password to continue.
2. Select Settings  Sensor settings, or press F11.
3. Click on Add/Update a module.
4. Select your receiver in the pick-list (“PC1” in Figure 7), then
select the wireless module from the sensor list on the left.
Figure 7 – Configuration with Cobalt 2 module on receiver
“PC1”
5. Click on Power to test the connection.
If this test does not show a wireless signal, please refer
to the Cobalt 2 User Guide for instructions on adding
modules into the system manually.