EasyManua.ls Logo

Ocea Soft Cobalt 2 User Manual

Default Icon
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
www.oceasoft.com | support@oceasoft.com
PROFESSIONAL MEASUREMENT TECHNOLOGY
Cobalt
®
2 Temperature
Monitor
(Internal and External Digital Probes)
Installation guide
Question and Answer IconNeed help?

Do you have a question about the Ocea Soft Cobalt 2 and is the answer not in the manual?

Ocea Soft Cobalt 2 Specifications

General IconGeneral
BrandOcea Soft
ModelCobalt 2
CategoryMeasuring Instruments
LanguageEnglish

Summary

Notices

Safety instructions

Important safety notes for product usage, disassembly, and emergency procedures.

Battery warning

Warnings about lithium battery handling, polarity, disposal, and contact with leaked liquid.

FCC statement

FCC compliance statement regarding harmful interference and operation conditions.

Conformity with European regulations

CE mark compliance statement for Radio Equipment Directive and applied standards.

WEEE compliance

Compliance with Waste Electrical and Electronic Equipment Directive.

Environmental protection

Reminder to respect local regulations for disposal and recycling.

RoHS compliance

Compliance with RoHS Directive restricting hazardous substances.

Disclaimer and limitation of liability

Oceasoft's disclaimer of responsibility for product use and document status.

Introduction

Pre-requisites

Assumed software and hardware setup for the installation guide.

Package contents

Lists included items: module, probes, mounting kit, and accessories.

Product overview

What is a Cobalt 2 temperature module?

Explains Cobalt 2 modules' function: reading, recording, and transmitting temperature data wirelessly.

Typical installation

Typical Cobalt 2 wireless configurations

Diagram and explanation of basic wireless configurations with receivers and repeaters.

Installation procedure

Before you begin

Steps to connect the temperature probe and capillary cable to the module.

Placing your Cobalt 2 module for best performance

Recommendations for optimal module placement to ensure good wireless communication.

Placing the probe within the enclosure

Guidance on positioning the probe inside refrigerators/freezers for accurate readings.

Recommended order for installing modules

Steps for optimizing network performance during module installation and activation.

Placing external probe and Cobalt 2 module

Placing external probe and Cobalt 2 module

Detailed steps for routing the probe via the door joint and attaching cable holders.

Activation and automatic wireless configuration

Activation and automatic wireless configuration

Instructions for activating the module and establishing a wireless connection.

Software configuration

Testing the connection

Steps to test wireless signal strength using ThermoClient software.

Basic module configuration

Guide on organizing modules into groups within the ThermoClient software.

Test module by running an on-demand temperature read

How to perform an on-demand read to confirm end-to-end communication in ThermoClient.

Additional configuration

Additional configuration

Overview of advanced settings available in ThermoServer/ThermoClient software for modules.

Appendix

Troubleshooting

Addresses common issues like no display, connection problems, and signal strength.

Specifications

Contact information

By e-mail

Contact details for technical support via email, requesting detailed information.

By phone

Contact details for technical support via phone, including operating hours.