Ocea Soft Cobalt 2 - Test module by running an on-demand temperature read

Software configuration | 15
4. Click on Yes  OK  Close to update the module, save this
change, and return to the tree structure, as shown here:
Figure 10 – Temperature sensor in “Main floor” group
Test module by running an on-demand temperature read
You may confirm end-to-end operation by launching an on-demand read
from ThermoClient.
1. Click on the sensor in the tree structure (“Temp Sensor 1” in our
example).
2. Click on the current temperature (black zone in the image
below) to read the sensor wirelessly and update the display:
Figure 11 – Run an on-demand read to confirm end-to-end
communication