12 | Cobalt Temperature Monitor Installation
Activation and automatic wireless configuration
The Cobalt 2 temperature monitor is a standalone device that runs on
battery power. To activate your Cobalt 2 module and add it automatically
to your wireless monitoring network:
1. Insert the provided battery, if not already installed, making sure
to respect the polarity (see image printed inside battery slot).
2. To begin collecting temperature data right away and initiate the
wireless configuration sequence, press the button on the front
of the module for 3 seconds.
If a receiver or repeater is within wireless range, the Cobalt 2
module automatically establishes the wireless connection,
as shown in the sequence of screen shots below:
Figure 6 – Cobalt 2 module automatic wireless set-up sequence
To Next Page
Loading...