14 | Cobalt Temperature Monitor Installation
Basic module configuration
Cobalt 2 modules offer a variety of data-logging, alert and transmission
options. This section describes the basic settings to get started right
away. Please see the complete Cobalt 2 User Guide for more details.
Move the Cobalt 2 module into a group
1. Launch ThermoClient on your computer and enter your login
name and password to continue. The new Cobalt 2 should be
listed as shown here, where “PC1” refers to the receiver and
“SDP-PC1” refers to a generic group for new un-configured
modules connected to that receiver.
Figure 8 – New temperature sensor in generic “SDP” group
2. Press F11 or select Settings Sensor settings.
3. Drag the new sensor from the “SDP” group to your real group:
Figure 9 – Move sensor from generic “SDP” group to your real
group
To Next Page
Loading...