8 | Cobalt Temperature Monitor Installation
Typical installation
Cobalt 2 modules transmit temperature readings and alerts to a PC
running Oceasoft ThermoServer/ThermoClient software, equipped with
a wireless receiver. The receiver may also be located remotely from the
PC on a network device server. Repeaters may be used when the
wireless range between the receiver and the Cobalt 2 end-point module
is too great. The diagram below shows these basic configurations:
Figure 2 – Typical Cobalt 2 wireless configurations
Each Cobalt 2 end-point module may only connect back
to one receiver as shown above. Any given module
cannot be read by multiple receivers.
Cobalt 2 modules may be installed on the outside of refrigerators and
freezers, with the probe place inside the enclosure and connected via
the provided capillary cable. Modules with internal probes should not be
placed in cold-rooms.
To Next Page
Loading...