Need help?Do you have a question about the Ocean Insight FLAME and is the answer not in the manual?
Details potential hazards and necessary precautions for operating the device safely.
Instructions for installing the necessary software and drivers for the FLAME spectrometer.
Step-by-step guide for connecting the FLAME spectrometer to a computer via USB.
Detailed pin assignment for the 40-pin accessory connector on the FLAME spectrometer.
Methods for synchronizing data acquisition with external events using trigger signals.
Procedure for calibrating the wavelength accuracy of the FLAME spectrometer.
General| Integration Time | 1 ms to 65 seconds |
|---|---|
| Weight | 190 g |
| A/D Resolution | 16-bit |
| Stray Light | <0.05% at 600 nm |
| Fiber Optic Connector | SMA 905 |
| Optical Resolution | ~1.5 nm (FWHM) |
| Interface | USB 2.0 |
| Power | 5 VDC via USB |
| Detector Pixel Size | 14 μm x 200 μm |
| Signal-to-Noise Ratio | 250:1 |
| Dynamic Range | 1300:1 |
| Operating Temperature | 0°C to 40°C |
| Spectral Range | 200-850 nm (grating dependent) |
To Next Page