To Next PageTo Next Page
Need help?Do you have a question about the Ocean Optics USB2000 Plus and is the answer not in the manual?
General| Spectral Range | 200-1100 nm |
|---|---|
| Pixels | 2048 |
| Interface | USB 2.0 |
| Power Supply | USB powered |
| A/D Resolution | 16-bit |
| Detector Elements | 2048 |
| Stray Light | < 0.05% at 600 nm |
| Detector Type | Linear CCD array |
| Pixel size | 14 μm x 200 μm |
| Resolution | 0.1 nm |
| Dynamic Range (system) | 2 x 10^8 |
| Signal-to-Noise Ratio | 300:1 |
| Detector | 2048-element Toshiba TCD1304AP |
| Dimensions | 89.1 mm x 63.3 mm x 34.4 mm |
Details the physical connection and driver installation for the spectrometer.
Explains how to configure the spectrometer for software use.
Troubleshooting steps for issues arising from pre-installation connection.
Procedure to remove unrecognized devices from Windows Device Manager.
Steps to clean up incorrect installation files on Windows.
Steps for performing the physical wavelength calibration procedure.
Detailed procedure for calibrating the spectrometer's wavelength.
Instructions for saving updated wavelength calibration to the device.
Lists key performance metrics and operational parameters of the unit.
Diagram showing the pin configuration of the 20-pin accessory connector.
Defines the function of each pin on the 20-pin accessory connector.
