To Next PageTo Next Page
Need help?Do you have a question about the Ocean Optics USB2000 and is the answer not in the manual?
General| A/D Resolution | 16-bit |
|---|---|
| Wavelength Range | 200-1100 nm |
| Spectral Resolution | 0.3-10.0 nm FWHM |
| Detector Type | Linear CCD array |
| Detector | Sony ILX511 |
| Interface | USB |
| Dynamic Range | 1300:1 (single acquisition) |
| Power | USB bus powered (2.5W max) |
| Integration Time | 65 seconds |
| Dimensions | 89.1 mm x 63.3 mm x 34.4 mm |
Describes the spectrometer's connection, power source, and necessary hardware/software.
Explains connection options, shipment contents, packing list, and calibration data sheet.
Details the included CD, other documentation, and modification/repair policy.
Illustrates the light path through the USB2000 spectrometer's optical bench.
Explains spectrometer components and lists CCD detector specifications.
Details the USB2000 spectrometer's dimensions, power, range, and optical specifications.
Outlines PC compatibility requirements and the 10-pin accessory connector location.
Step-by-step instructions for connecting the USB2000 via USB or serial port.
Instructions on configuring OOIBase32 to recognize and operate the USB2000.
Addresses installation problems and steps to remove unknown devices from Device Manager.
Specific instructions for removing driver files in Windows 98.
Steps to troubleshoot serial port connections and guidance for OOIBase32 version issues.
Steps to configure the USB2000 and OOIBase32 before conducting experiments.
Explains and details procedures for absorbance, transmission, and reflection measurements.
Covers relative irradiance and time acquisition experiments and their setup.
Explains calibration basics, pixel-wavelength relationship, and required materials.
Step-by-step guide for performing spectrometer wavelength calibration using spectral lines.
Instructions for saving new calibration coefficients via USB or serial mode.
Information about the USB2000-FLG spectrometer and its enhanced sensitivity.
Instructions for installing and configuring the USB2000-FLG for Variable Delay Mode.
