BA_OTE 3+4_Endkunde_EN_V03_20170726.docx Page 20 of 52
5.15 Set temperature manual operation
For the "Manual operation heating" or "Manual operation cooling" selection, a fixed set
temperature is used for the control. To activate the manual operation, see Section 5.3.
ATTENTION
The heating and cooling limits are not active in this mode!
Control is to the set temperature, independent of the current outside tempera-
ture.
Settings procedure:
1. Press the adjustment knob in the main
display > the main menu appears
2. Select the Heating Circuit by turning the
adjustment knob and confirm by pressing
the knob. > the temperature image for the
heating circuit appears.
All heating circuits are always displayed in
the main menu.
3. In heating circuit temperature image, se-
lect the heating circuit menu by pressing
the adjustment knob.
4. Operation mode selection 7 in the heating
circuit menu: Select Manual heating mode
and confirm by pressing the adjustment
knob
5. By turning the adjustment knob, select
Setpoint temperature manual operation
mode and confirm this by pressing the
knob.
6. Change/adjust the parameter by turning
the adjustment knob and store this by
pressing. By repeated pressing of the ESC –
knob you return to the main display.
Setpoint temperature manual
To Next Page
Loading...
Need help?
General