BA_OTE 3+4_Endkunde_EN_V03_20170726.docx Page 26 of 52
7.3 Time program for hot water
Time program
Hot water
Description
The time of day at which the hot water charging at normal or
energy saving temperature takes place is set here.
Hot water anti Legionella
time program
The time at which the increased Legionella protection tem-
perature is active is set here.
(Depending on the type of system, the heating to Legionella
protection temperature will (partly) done by th
heater - but only when the heat pump has switched off via
the max. flow temperature limiter - i.e. a higher temperature
Settings procedure:
1. Press the adjustment knob in the main
display > the main menu appears
2. Select the Hot Water Circuit by turning the
adjustment knob and confirm by pressing
the knob. > the temperature image for the
hot water circuit appears.
3. In hot water temperature image, select the
hot water menu by pressing the adjust-
ment knob.
4. By turning the adjustment knob, select
Settings in the hot water menu and con-
firm this by pressing the knob.
5. By turning the adjustment knob, select
time program and confirm this by pressing
the knob.
7. By turning the adjustment knob, select the
desired time program and confirm this by
pressing the knob. > Adjust the time pro-
gram according to the description (see Sec-
tion 7.1)
To Next Page
Loading...
Need help?
General