© 2016 Octagon Systems Corporation Page 11 of 17
Digital I/O
The TRAX-10 provides one digital output. When activated, it provides a ground for external
devices connected to the vehicle voltage. When inactive it appears as an open. The line can
withstand voltages up to 100V when in the off state and can sink 100 mA when active.
The output line will provide 1A peak repetitive for 50mS for driving incandescent lamps
switching on at a rate of one per second, at a 50% duty cycle with a 50mA lamp. The output
line has inductive load protection with a 1A, 100V diode across the load, and the cathode
connected to the supply voltage.
The TRAX-10 also provides five digital inputs. The inputs detect a positive voltage with an
input range of 0V to +Battery. The input is inactive when open (less than 100mA) and active
when connected to a positive voltage of 4-36VDC.
Note that drivers written by Octagon indicate a binary value of 0 when the input is
open/inactive, and 1 when active.
Storage
The TRAX10 uses a (SATA) solid state storage device to act as the system hard disk drive.
Storage options are available from 32 GB to 512 GB. All storage options must be factory
installed.
Status LEDs
The TRAX-10 has 3 front panel status LEDs:
LAN indicates LAN link (green) and activity (yellow).
STAT is a user controlled bi-color status LED. Accessing the LED registers is
accomplished through operating system drivers. Contact Octagon for driver
availability and/or a Board Support Package for your Operating System.
PWR is a Power indicator, indicating On (Green) or Standby (Yellow) state of the
power supply.
The TRAX 10 has 4 rear panel Ethernet status LEDs, one for each Ethernet port. Each bi-color
LED indicates:
GREEN ON /GREEN BLINKING = 100Mb operation + Activity
GREEN BLINKING / YELLOW ON = 1Gb operation + Activity
---------- ♦♦♦ ----------
To Next Page
Loading...
General