REMOTE CONTROL FOR VOLUME
Remote control operating elements
16
REMOTE CONTROL FOR VOLUME
Remote control operating elements
Legend
(1)
Volume up
(2)
Volume down
Battery replacement
1. Use a “Philips 1” screwdriver to disassemble the base plate.
2. Remove the batteries.
3. Insert two new AAA 1.5 V batteries.
Tip Make sure not to press the buttons while inserting the batteries!
If the remote control does not work after the batteries are replaced, remove the new
batteries and wait at least 2 hours.
You can then re-insert the batteries and the remote control should work.
4. Replace the base plate taking care not to tighten the screws too much.
Note
After use, the batteries we have supplied for the remote control can be returned to the
point of sale free of charge. Please do not throw them in the garbage.
You cannot control the volume with the remote control in case of the option stepped
attenuator.
To Next Page
Loading...
Need help?
General
