(15)Headlight (low beam)/turn
lights
The low beam is for close lighting
(16) Headlight (high beam)
The high beam can improve the line
of sight and expand the field of view.
(17) Winch
The winch can be actuated using the
winch control switch or with the
remote control (sold separately).
NOTE: Using the winch intensively
over a long period of time may
discharge the battery.
The following tips will help to reduce
the risk of discharging the battery:
Always unreel manually: Unlock the
cable using the handle then pull on
the hook strap to unreel.
It is recommended to let the vehicle
run while winching. Do not stop
vehicle immediately after winching to
let battery recharge.
Also, when winching for more than
30 seconds, it is recommended to
increase engine RPM in the range of
3000 RPM to increase charging
power to the battery.
NOTE: Make sure vehicle is in
NEUTRAL (N) before increasing
engine RPM.
Refer to BASIC GUIDE TO
WINCHING ТЕCHNIQUES for more
informatic about the winch.
To power up the vehicle without
starting the engine, refer to WAKING
UP THE ELECTRICAL SYSTEM.
GENERAL SAFETY
PRECAUTIONS
REGARDING THE USE
OF WINCH
AWARNING;
Moving Part hazards
To prevent serious injury and
property damage:
Do not operate or install winch
without reading and understanding
these instructions and the Basic
Guide to Winching Techniques.
Keep hands clear of wire rope, hook
and fairlead opening during
operation and when spooling.
Use supplied hook strap for
spooling wire rope.
Stand clear of wire rope and load
during operation.
Keep others away.
Inspect winch installation and wire
rope condition before operating
winch.
Do not use as a hoist.
Do not use to move persons.
Do not exceed winch's rated
capacity.
To Next Page
Loading...
Need help?
General
