Before using this vehicle, the operator should always perform the following
pre-ride inspection check list.
Pre-Ride Inspection Check List
What to Do Before Starting the Engine (Key OFF)
Check for any leaks under vehicle.
Activate throttle lever several times to ensure it
operates freely. It must return to idle position when
released.
Apply parking brake and check if it operates
properly.
Check tire pressure and condition.
-Front: 45kPa(7 PSI)
-Rear:45kPa(7 PSI)
Check wheels for damage and for abnormal play,
and check lug nuts are tightened.
Check cleanliness of the radiator.
Check drive shaft boots and protectors condition.
Check if operator seat is in place and properly
latched.
If you transport a cargo, respect the load capacity.
Ensure cargo is properly secured to the rear cargo
area.
If you are pulling a trailer or an other equipment:
- Check hitch and trailer ball condition
- Respect the tongue capacity and towing capacity.
- Ensure trailer is properly secured to hitch.
Check if glove box is properly locked in position.
Check if rear storage compartments are properly
latched.
Check underneath vehicle for any debris on
chassis or suspension and clean them properly.
To Next Page
Loading...
Need help?
General
