capacity.
Start engine and let it idle for a few
minutes. Ensure oil filter area and oil
drain plug areas are not leaking.
Stop engine. Wait a while to allow
oil to flow down to the crankcase
then check oil level. Refill as
necessary. Dispose of oil as per
your local environmental regulations.
Engine Coolant
Engine Coolant Level
heck coolant level with engine cold.
Never add coolant in cooling' system
when engine is hot.
TYPICAL
1. Radiator cap
2. Engine coolant reservoir
1. Remove the radiator cap by
applying. pressure and turning it
counterclockwise.
Then drain the antifreeze from the
engine.
Complete the radiator filling.
Check the level in the coolant
reservoir and refill if necessary
Run engine at idle with the radiator
cap off.
Slowly add coolant if necessary. At
this point, wait until engine reaches
normal operating temperature.
2.With vehicle on a level surface,
liquid should be between MIN. and
MAX. level marks of coolant
reservoir.
NOTE: When checking level at
temperature lower than 20° ℃
(689F), it may be slightly lower than
MIN. mark.
NOTE: Ensure coolant reservoir
hose is properly routed to avoid any
interference when closing cover.
To Next Page
Loading...
Need help?
General
