Post-Operation Care
When vehicle is used in salt-water
environment (beach area,
launching/loading boats etc.), rinsing
the vehicle with fresh water is
necessary to preserve vehicle and its
components. Metallic parts
lubrication is highly recommended.
This must be performed at the end of
each operating day.
When vehicle is operated in muddy
conditions, rinsing the vehicle is
recommended to preserve vehicle
and its components and to keep
lights clean.
NOTE: Never use the high pressure
washer to clean the vehicle USE
LOW PRESSURE ONLY (like a
garden hose). The high pressure can
cause electrical or mechanical
damages.
Storage
When a vehicle is not in use for more
than one month, proper storage is a
necessity. Do key parts maintenance
work according to MAINTENANCE
CHART
SPECIAL PROCEDURES
What to Do if Water is in the CVT
The CVT drain plug is located on the
rear portion of the CVT cover. It is
accessible from the rear LH fender.
Inspect the CVT drain plug to
validate if water is present.
NEAR LH FOOTREST
1.Spring clamp
2.Drain plug
NOTE: If water entered your CVT
while in a muddy environment, limit
vehicle usage and bring your vehicle
to your nearest authorized dealer for
a proper CVT cleaning procedure.
If water is present, remove CVT
drain plug to expel water.
Reinstall the drain plug and secure it
using the spring clamp.
NOTE: Make sure drain plug is
properly inserted on CVT cover
nipple.
To Next Page
Loading...
Need help?
General
