What to do if OHAUS AP250D display locks up?
If the OHAUS Scales display is showing random segments or the display locks up, it might be due to the microprocessor locking up. Try turning the power off, and then turn it back on. If the issue continues, the unit needs servicing.
Why OHAUS AP250D Scales showing incorrect weight?
If you are getting an incorrect weight reading on your OHAUS Scales, it could be that the balance was not re-zeroed before weighing or it is not properly calibrated. Press the ON button with no weight on the pan to re-zero it, then weigh the item. If problems persist, recalibrate the scales correctly.
Why is the RS232 interface not working on OHAUS Scales?
If the RS232 interface is not working on your OHAUS Scales, the print menu settings may not be properly set up, or there could be cable connection issues. Verify that the interface settings in the Print menu correspond to those of the peripheral device and check the cable connections.
What to do if unable to change settings on OHAUS Scales?
If you're unable to change settings on your OHAUS Scales, the lock might be set to ON. (LFT set ON) Set the Lock switch to OFF to enable changes.
Why OHAUS AP250D giving unstable readings?
If you're getting unstable readings on your OHAUS Scales, it could be due to vibration on the table surface. Place the balance on a stable surface or change the averaging level.
What to do if unable to store menu settings on OHAUS AP250D Scales?
If you cannot store menu settings/changes on your OHAUS Scales, make sure you are using the End function to exit the menus. You MUST use End to exit menus and save settings.
Guide on how to access and move through the balance's menu system.
Covers weighing, taring, percent, parts counting, check weighing, animal weighing, and fill guide.
Details on auto, user, and test calibration methods.
Common problems and their solutions for balance operation.
Lists various error codes and their corresponding remedies.
General| Capacity | 250 g |
|---|---|
| Pan Size | 90 mm |
| Display | LCD |
| Stabilization Time | 2 seconds |
| Power Supply | AC Adapter |
| Units of Measurement | g, oz |
| Interface | RS232 |
| Operating Temperature | 15°C to 30°C |
| Calibration | External Calibration |
To Next Page
