Why my OHAUS Catapult 1000 Scales will not turn on?
If your OHAUS Scales won't turn on, there are a couple of things to check: * **Power Source:** Make sure the scale is properly connected to a power source and that the voltage is correct. Try connecting the power and replacing the batteries. * **Battery Condition:** If you're using battery power, the batteries might be drained. Try replacing them.
What to do if my OHAUS Catapult 1000 Scales display -E-?
If your OHAUS Scales display '-E-', it means the scale is overloaded. Remove some weight from the platform.
What to do if OHAUS Scales display 000000 or 999999 or no weight reading?
If your OHAUS Scales display '000000' or '999999', or there is no weight reading, it could be due to: * **Load Cell Cable:** The load cell cable may be disconnected. Connect the load cell cable to the scale and then calibrate the scale. * **Calibration Data:** There might be no calibration data in the EEPROM. Connect the load cell cable to the scale and then calibrate the scale.
How to improve accuracy of OHAUS Catapult 1000?
If your OHAUS Scales are showing poor accuracy, it might be due to: * **Calibration:** The scale may need to be calibrated. Perform a calibration. * **Environment:** The scale could be in an unstable environment. Move it to a more suitable, stable location.
Why I am unable to calibrate my OHAUS Catapult 1000 Scales?
If you're unable to calibrate your OHAUS Scales, consider these potential causes: * **Environment:** An unstable environment can interfere with calibration. Move the scale to a stable location. * **Calibration Mass:** Using the wrong calibration mass can also cause issues. Ensure you are using the correct calibration mass.
What does CALE mean on OHAUS Catapult 1000 Scales?
If your OHAUS Scales display 'CALE', it indicates a calibration error. Stop the calibration process, check that you are using the correct weight, and then try again.
What does -A- mean on OHAUS Scales?
If your OHAUS Scales display '-A-', it means the scale is in Dynamic Weighing Mode. If you want to exit, remove the mass from the platform and press UNITS Cal.
What does UnSt mean on OHAUS Catapult 1000 Scales?
If your OHAUS Scales display 'UnSt', it means the scale was unstable at power on. Make sure the environment is stable, the scale is on a flat surface, and check the adjustable feet.
What does Lo bat OFF mean on OHAUS Catapult 1000 Scales?
If your OHAUS Scales display 'Lo bat OFF', it means the scale shut down due to low battery. Replace the batteries.
What does Lo Line OFF mean on OHAUS Catapult 1000?
If your OHAUS Scales display 'Lo Line OFF', it indicates a low line voltage shutdown, which is a power adapter problem. If the input voltage is unstable, try switching to battery operation.
To Next Page
General
