How to fix OHAUS Navigator NV2201 that cannot turn on?
If your OHAUS Scales won't turn on, the issue is likely due to a lack of power. Verify the connections and voltage to ensure the scale is receiving power.
What to do if OHAUS Scales cannot calibrate?
If you cannot calibrate your OHAUS Scales, the issue might stem from an unstable environment or using an incorrect calibration weight. Try moving the balance to a more stable location. If that doesn't work, make sure you are using the correct calibration weight.
What does 'Lo ref' mean on OHAUS Navigator NV2201 Scales?
If your OHAUS Scales display 'Lo ref', it means the reference weight is too low. Increase the reference weight to resolve this issue.
Why can't I access a mode on my OHAUS Navigator NV2201 Scales?
If you cannot access a specific mode on your OHAUS Scales, it is possible that the mode is not enabled. Enter the menu and enable the desired mode.
Why can't I access a unit on my OHAUS Navigator NV2201?
If you cannot access a specific unit on your OHAUS Scales, it is possible that the unit is not enabled. Enter the menu and enable the unit.
Defines signal warnings and symbols used in the manual for hazard communication.
Lists essential safety precautions for installing and operating the equipment to prevent injury or damage.
Describes how to connect the AC adapter and install batteries for powering the balance.
Guides users through the process of calibrating the balance for accurate measurement results.
Outlines the steps to operate the balance in standard weighing mode.
Lists common problems, their possible causes, and recommended remedies for the balance.
General| Capacity | 2200 g |
|---|---|
| Readability | 0.1 g |
| Display | LCD |
| Linearity | ± 0.2 g |
| Repeatability | 0.1 g |
| Calibration | External calibration |
| Power Supply | AC adapter |
| Operating Temperature | 10 °C to 40 °C |
| Units of Measurement | g, oz |
| Interface | RS232 |
To Next Page
