OHAUS Navigator Balance User Manual

Quick Start Guide Navigator

Balance
Ohaus Corporation www.ohaus.com i Navigator

Balance Quick Start Guide
PREPARATION FOR USE
Release Shipping Lock under the balance
Rotate the pointer to the unlocked position.
Note: No shipping lock on Approved models.
Connect Power
Ensure voltage identification label matches local
line voltage. If not, do not connect the unit.
Contact Ohaus or your dealer.
Battery Installation
Install the batteries with polarity as shown in the
battery compartment.
Use the AC Adapter to power the balance
when battery power is not needed.
Connect the AC Adapter plug
to the input jack.
Slide appropriate power
plug for your country onto
the adapter housing.
Connect AC Adapter to
the proper AC supply.
SELECTING THE LOCATION: Place on a firm, steady surface with sufficient space.
Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.
Adjust the leveling feet so
the bubble is centered
in the circle.
Battery
Cover
Input Jack

OHAUS Navigator Balance Specifications

General

Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Display	LCD
Power Supply	AC adapter or rechargeable battery
Operating Temperature	10°C to 40°C
Units of Measurement	g, kg, oz, lb, ct
Interface	RS232
Construction	Stainless steel

Summary

Preparation For Use

Release Shipping Lock

Release shipping lock and rotate pointer to unlocked position. Note: no shipping lock on approved models.

Connect Power

Ensure voltage identification label matches local line voltage. If not, do not connect the unit.

Selecting the Location

Adjust Leveling Feet

Adjust leveling feet to center the bubble in the circle for a stable reading.

Safety Precautions

Controls Overview

Control Panels

Button Functions

Details short and long press actions for all balance buttons like Zero, Tare, Function, Mode, etc.

Operation

Weighing

Power on using Zero. Long-press Function/Mode until Weigh Mode appears. Place sample on platform.

Taring Container Weight

Place empty container on platform, press Tare to zero. Then place material for accurate sample weight.

Menu Navigation