Need help?Do you have a question about the OHAUS RANGER 3000 and is the answer not in the manual?
General| Readability | 0.1 g to 1 g |
|---|---|
| Display | LCD |
| Power | AC adapter or rechargeable battery |
| Interface | RS232 |
| Operating Temperature | 0°C to 40°C |
| Application | Weighing, Parts Counting, Check Weighing, Dynamic Weighing |
| Construction | Stainless steel platform |
| Units | g, kg, lb, oz, lb:oz |
| Capacity | 3 kg to 30 kg |
| Platform Size | 300 x 225 mm |
Explains the OHAUS USB Interface Kit for connecting scales to computers via USB, using a generic RS232-based interface.
Lists the components included in the USB Interface Kit, such as the USB PC Board, screws, cable, and manual.
Details the necessary PC operating systems (Windows 98 to 7) and an available USB port for the interface kit.
Provides initial steps for installing the interface module on the balance, including removing the cover.
Details installing the Interface PCB with screws and connecting the USB cable, then replacing the cover.
Explains connecting the USB cable to the computer and Windows' detection of the new hardware.
Guides users through installing the software drivers from the CD to create a virtual port on the computer.
Describes preset communication settings (baud, parity, handshake) and how to configure balance USB/printing parameters.
Explains how the balance operates with the USB adapter, detailing Auto Print and Stable settings.
Details the standard ASCII format of data sent from the interface, including field definitions and output examples.
Explains that the balance responds to commands sent via the interface adapter, terminating with CRLF.
Lists and explains specific commands for controlling balance operations like printing, zeroing, taring, and unit selection.
Describes how to temporarily stop and resume auto-printing using the PRINT key.
Provides information on the proper disposal of the device according to WEEE directives and local regulations.
To Next Page
