Ethernet Interface EN-3
Input
The scale will respond to various commands sent via the interface.
Immediate Print of displayed weight (stable or unstable).
Print displayed weight (stable or unstable).
0S: Turn off “Stable Only” menu item and allow unstable print. 1S: Turn on “Stable
Only” menu item and only print stable print.
Interval Print x = Print Interval (1-3600 sec), 0P turns auto print OFF.
Same as pressing Zero Key.
Same as pressing Tare Key.
Download Tare value in grams (positive values only).
Sending 0T clears tare (if allowed).
Print current unit: g, kg, lb, oz, lb:oz, t, c (custom).
Set scale to unit x: 1=g, 2=kg, 3=lb, 4=oz, 5=lb:oz, 6=t.
Set scale to mode x. M will scroll to next enabled mode.
Version: print name, software revision and LFT ON (if LFT is set ON).
Enter Header line, where x = line number 1 to 5, “text” = header text up to 24
alphanumeric characters.
Enter Footer line, where x = line number 1 to 2, “text” = rear text up to 24 alphanumeric
characters.
Global reset to reset all menu settings to the original factory defaults
(Escape key + ‘R’ Key).
Auto-Print Operation
Once Auto-Print is activated in the menu, the balance will send data as required. To temporarily stop
Auto-Printing, press the PRINT key. If there is data in the print buffer the printer will finish printing this
data. A second press will resume Auto-Printing.
(Note: In some modes, stopping or resuming Auto-Print must be done when the balance is not
reading “0”.)
ACCESSORIES
For a complete listing of OHAUS printers and other accessories, contact OHAUS Corporation or visit
www.OHAUS.com
To Next Page
Loading...
Need help?
General
