OHAUS ST300 - Page 8

EN-4 STARTER 300 Portable pH Meter
Controls
Button
Press & release
Press & hold
for 3 seconds
- Start or endpoint measurement
- Confirm setting, store entered
value
- Turn auto endpoint on / off
,
- Start calibration
- Review the latest calibration
data (slope, offset)
- Meter turn on
- Return to measurement screen
- Meter turn off
- Store current reading to memory
- Increase value during setting
- Scroll up through the memory
- Recall stored data
- Switch between pH and mV
measuring modes
- Decrease value during setting
- Scroll down through the memory
- Enter setup mode
- Start self-diagnosis