Need help?Do you have a question about the OHAUS STARTER 300D and is the answer not in the manual?
General| Model | STARTER 300D |
|---|---|
| pH Resolution | 0.01 pH |
| pH Accuracy | ±0.01 pH |
| Temperature Resolution | 0.1 °C |
| Temperature Accuracy | ±0.5 °C |
| Calibration Points | Up to 3 points |
| Display | LCD |
| Operating Temperature | 5 to 40 °C |
| Type | Bench pH Meter |
| mV Range | -1999 to 1999 mV |
| mV Accuracy | ±1 mV |
| Temperature Range | 0 to 100 °C |
| Power Supply | AC Adapter or 4 AA Batteries |
| Auto-off | After 30 minutes of inactivity |
| Units | °C |
Explains signal words (WARNING, CAUTION, Attention, Note) and warning symbols for safety.
Provides crucial safety instructions for operating the STARTER 300D meter.
Details the meter's display layout and indicators.
Lists the items included in the ST300D-B and ST300D packages.
Provides step-by-step instructions for installing batteries in the meter.
Details how to attach and position the electrode clip on the meter housing.
Illustrates the process of using a plastic tool to install IP54 cover caps.
Explains how to use and close the integrated table stand of the meter.
Explains the importance and steps for setting barometric pressure and units.
Details how to select the unit (mbar, hPa, mmHg) for barometric pressure.
Guides on adjusting the numerical value for barometric pressure.
Explains how to set the salinity value for accurate dissolved oxygen compensation.
Covers setting Manual Temperature Compensation (MTC) when no electrode is detected.
Explains how to switch between Celsius (°C) and Fahrenheit (°F) for temperature.
Guides on adjusting the numerical temperature value for MTC.
Explains how to enable or disable the auto-shutoff feature for continuous operation.
Details the procedures for calibrating the DO meter.
Explains how to prepare the zero-oxygen solution for calibration.
Guides on how to perform a single-point calibration using Auto or Manual mode.
Details the steps for performing a two-point calibration using the zero-oxygen solution.
Provides instructions for taking dissolved oxygen measurements of samples.
Explains temperature measurement, including ATC and MTC modes.
Describes how to use the meter's memory for storing readings.
Guides on how to store current measurement results in the meter's memory.
Explains how to retrieve stored readings from the meter's memory.
Guides on how to delete stored data from the meter's memory.
Lists common error messages and their troubleshooting solutions.
Provides general maintenance advice for the meter housing.
Details proper care and handling procedures for the DO sensor electrode.
Explains how to perform the meter's self-diagnosis function.
Guides on how to reset the meter to its original factory settings.
Lists the detailed technical specifications of the STARTER 300D meter.
To Next Page
