OHAUS STARTER 300D - English; Default Chapter; Table of Contents

TABLE OF CONTENTS
1
INTRODUCTION ...................................................................1
1.1 Definition of Signal Warnings and Symbols ...................................... 1
1.2 Safety Precautions ............................................................................ 2
1.3 Display and controls .......................................................................... 3
2 INSTALLATION.....................................................................5
2.1 Package contents .............................................................................. 5
2.2 Installing the batteries ....................................................................... 5
2.3 Installing the electrode clip ................................................................ 6
2.4 Installing the IP54 cover caps ........................................................... 6
2.5 Integrated stand for table top use ..................................................... 6
3 SETUP...................................................................................7
3.1 Setting barometric pressure .............................................................. 7
3.1.1 Setting the barometric pressure unit ............................................. 7
3.1.2 Setting the barometric pressure value .......................................... 7
3.2 Setting salinity value ......................................................................... 7
3.3 Setting MTC value ............................................................................. 8
3.3.1 Setting the temperature unit .......................................................... 8
3.3.2 Setting the MTC temperature value .............................................. 8
3.4 Setting the meter always working mode ........................................... 8
4 STARTER 300D OPERATION ..............................................9
4.1 Calibration ......................................................................................... 9
4.1.1 Zero-oxygen solution ..................................................................... 9
4.1.2 Performing 1-point calibration ....................................................... 9
4.1.3 Performing 2-point calibration ..................................................... 10
4.2 Sample measurement ...................................................................... 11
4.3 Temperature measurement .............................................................. 11
4.4 Using the memory ............................................................................ 11
4.4.1 Storing a reading .......................................................................... 11
4.4.2 Recalling from memory ............................................................... 12
4.4.3 Clearing the memory ................................................................... 12
5 MAINTENANCE ..................................................................13
5.1 Error message ................................................................................. 13
5.2 Meter maintenance.......................................................................... 13
5.3 Electrode maintenance ................................................................... 13
5.4 Self-diagnosis .................................................................................. 14
5.5 Recover factory settings .................................................................. 14
6 TECHNICAL DATA.............................................................15
6.1 Specifications ................................................................................ 15
6.2 Compliance ..................................................................................... 16