To Next PageTo Next Page
Need help?Do you have a question about the OHAUS STARTER 3100C and is the answer not in the manual?
General| Model | STARTER 3100C |
|---|---|
| Manufacturer | OHAUS |
| Weighing Capacity | 3100 g |
| Stabilization Time | 3 seconds |
| Operating Temperature Range | 10°C |
| Power | AC adapter |
| Display | LCD |
| Units of Measurement | g, kg, oz, lb, ozt, dwt, ct |
Explains safety notes, signal words (WARNING, CAUTION, Attention, Note), and warning symbols.
Provides essential safety warnings for installation, operation, and servicing the equipment.
Details the icons and segments of the meter's display for various readings and modes.
Describes the function of each button when pressed or held for specific operations.
Lists all items included in the STARTER 3100C-B and ST3100C-F packages.
Instructions for assembling the electrode holder arm on the meter base.
Guidance on connecting the power adapter to the meter.
Details on where to connect the conductivity electrode using the 'COND.' socket.
Describes the feature allowing adjustment of the display's view angle.
Information about the quick guide attached to the bottom housing of the meter.
Instructions on how to set the temperature unit to °C or °F.
Procedure to set the manual temperature compensation (MTC) value.
Guidance on selecting the appropriate calibration standard.
How to set the temperature correction coefficient (a-value).
Procedure for setting the Total Dissolved Solids (TDS) factor.
Instructions on the initial calibration process before measurement.
Details on choosing from the four predefined calibration standards.
Step-by-step guide for performing calibration using auto or manual endpoint modes.
Procedure for taking conductivity measurements of samples.
How to perform measurements for Total Dissolved Solids and Salinity.
Instructions for storing, recalling, and clearing measurement data.
Details on how to print measurement and calibration data.
Lists common error codes and their meanings/solutions.
Guidelines for cleaning and general upkeep of the conductivity meter.
Procedure for running the meter's self-diagnostic function.
Steps to reset the meter to its original factory settings.
Detailed technical specifications including measuring ranges, accuracy, and environmental conditions.
Information regarding EMC, Low Voltage, WEEE, FCC, and ISO 9001 compliance.
Table of conductivity standard values at different temperatures.
Provides temperature coefficients for various substances and standards.
Lists conversion factors for estimating TDS from conductivity readings.
