Need help?Do you have a question about the OHAUS AB41PH-F and is the answer not in the manual?
General| Model | AB41PH-F |
|---|---|
| Type | Analytical Balance |
| Readability | 0.1 mg |
| Weighing Capacity | 41 g |
| Pan Size | 90 mm |
| Repeatability (std dev) | 0.1 mg |
| Linearity | ± 0.2 mg |
| Stabilization Time | 3 seconds |
| Temperature Compensation | Yes |
| Display | LCD |
| Interface | RS232 |
| Measurement Range | 0 g to 41 g |
| Operating Temperature Range | 10°C - 30°C |
| Calibration | Internal Calibration |
| Power | AC Adapter |
| Units of Measurement | g, mg |
| Relative Humidity | 10% - 80% |
Essential safety guidelines and warnings for operating the equipment.
Configuration settings for pH measurement, including temperature and buffer groups.
Step-by-step guide for calibrating the pH electrode.
Procedures for performing pH, mV, ORP, and temperature measurements.
Configuration settings for conductivity measurement, including cell K value and standards.
Procedure for calibrating the conductivity measurement.
Steps for performing conductivity and related measurements like TDS and Salinity.
Detailed instructions for measuring TDS, Salinity, and Resistivity.
Lists common error codes and their corresponding possible solutions.
To Next Page
