OHAUS STARTER 3100C - Using the Memory; Printing

EN-12 STARTER 3100C Bench Conductivity Meter
4.4 Using the memory
4.4.1 Storing a reading
The STARTER 3100C can store up to 99 endpoint results.
 Press when the measurement reaches endpoint. M01 indicates that one result has
been stored.
If you press when M99 is displayed, FUL displays to indicate the memory is full. To store
further data you will have to clear the memory. (See 3.4.3)
4.4.2 Recalling from memory
 Press and hold to recall the stored values from memory when the current
measurement reaches endpoint.
 Press or to scroll through the stored results. R01 to R99 indicates which result
is being displayed.
 Press to exit.
4.4.3 Clearing the memory
 Pressing or to scroll through the stored results until “MRCL” appears.
 Press , CLr blinks;
Now we can two choices:
 Press to confirm the deletion of all the stored data.
 Press to return to the measurement mode without deleting the memory.
4.5 Printing
If a printer (e.g. SF-F40A) is connected to the STARTER 3100C, a print-out is automatically
generated after each end pointed measurement or calibration. (printer baud rate 9600bps; 8 data
bit; none parity bit; 1 stop bit)
The format for the print-out following a Cond. measurement is:
End Point, Value, Temp., ATC/MTC
Auto EP, 68.8μS/cm, 26.8°C , ATC
Ref.25°C , T.Comp.Coeff. 2.00%/°C