OHAUS T32ME - User Manual

Other manuals for OHAUS T32ME

Service Manual46 pages

User Guide40 pages

Questions and Answers

A
Amy ConnerSep 23, 2025
What does Err 9.0 mean on OHAUS Touch Panel?
- A
  Ariel MorganSep 23, 2025
  If the OHAUS Touch Panel displays 'Err 9.0', it indicates an internal fault, and service is required.
R
Ryan YorkAug 23, 2025
What to do if OHAUS Accessories scale will not zero?
- A
  Amy McgrathAug 23, 2025
  If your OHAUS Accessories scale won't zero, first remove any load exceeding the allowable limits. Then, ensure the load on the scale is stable before attempting to zero it.
R
Renee LopezAug 25, 2025
How to unlock menu settings on OHAUS Accessories?
- L
  lindsey03Aug 26, 2025
  If you cannot change the menu settings on your OHAUS Accessories, the menu may be locked. Set the selected menu to Off in the Lock Menu. Also, check that the Lock switch is set to the off position.
C
Christopher RangelAug 27, 2025
Why can't I change the weighing unit on my OHAUS Accessories?
- C
  Cory GardnerAug 27, 2025
  If you cannot display the weight in your desired weighing unit on your OHAUS Accessories, make sure the unit is set to On in the Units Menu.
T
tpetersonAug 27, 2025
What does Err 5.0 mean on OHAUS Accessories and how to fix it?
- M
  Mr. Ronald Donovan MDAug 27, 2025
  Err 5.0 on your OHAUS Accessories indicates that the display value is greater than 999999 in parts counting mode. To resolve this, reduce the number of parts.
C
Christina JohnsonSep 18, 2025
What does Err 53 mean on OHAUS Touch Panel?
- S
  Sean HickmanSep 18, 2025
  If the OHAUS Touch Panel displays 'Err 53', it indicates that the EEPROM data is incorrect, and service is required.
A
Angela MccallSep 15, 2025
What does LOW.rEF mean on OHAUS Touch Panel?
- L
  laurahollowaySep 15, 2025
  If the OHAUS Touch Panel displays 'LOW.rEF', it's a warning that the average piece weight of the parts is small. Use parts with an average piece weight greater than or equal to 1 division.
M
michaelwoodardSep 16, 2025
What does REF.WT Err mean on OHAUS Touch Panel?
- C
  Charlene BryantSep 16, 2025
  If the OHAUS Touch Panel displays 'REF.WT Err', it indicates that the average piece weight of the parts is too small. Use parts with an average piece weight greater than or equal to 0.1 division.
M
Mrs. Sonia HarrisSep 6, 2025
What does error 8.2 mean on OHAUS Touch Panel?
- M
  Mark GutierrezSep 6, 2025
  If the OHAUS Touch Panel displays 'Error 8.2', it indicates the weight reading is below the Power On Zero limit. To correct this, add a load to the scale and then recalibrate.
B
Brian ClarkSep 4, 2025
What does Error 8.4 mean on OHAUS Touch Panel and how to resolve it?
- A
  ariel28Sep 4, 2025
  If the OHAUS Touch Panel displays 'Error 8.4', it means the weight reading is below the Underload limit. To resolve this, add load to the scale and then recalibrate it.