To Next Page
L
Laura TaylorSep 23, 2025
What does Err 9.0 mean on OHAUS Touch Panel?
- RRoger RoblesSep 23, 2025
If the OHAUS Touch Panel displays 'Err 9.0', it indicates an internal fault, and service is required.
What does Err 9.0 mean on OHAUS Touch Panel?
If the OHAUS Touch Panel displays 'Err 9.0', it indicates an internal fault, and service is required.
What to do if OHAUS Accessories scale will not zero?
If your OHAUS Accessories scale won't zero, first remove any load exceeding the allowable limits. Then, ensure the load on the scale is stable before attempting to zero it.
How to unlock menu settings on OHAUS Accessories?
If you cannot change the menu settings on your OHAUS Accessories, the menu may be locked. Set the selected menu to Off in the Lock Menu. Also, check that the Lock switch is set to the off position.
Why can't I change the weighing unit on my OHAUS Accessories?
If you cannot display the weight in your desired weighing unit on your OHAUS Accessories, make sure the unit is set to On in the Units Menu.
What does Err 5.0 mean on OHAUS Accessories and how to fix it?
Err 5.0 on your OHAUS Accessories indicates that the display value is greater than 999999 in parts counting mode. To resolve this, reduce the number of parts.
What does Err 53 mean on OHAUS Touch Panel?
If the OHAUS Touch Panel displays 'Err 53', it indicates that the EEPROM data is incorrect, and service is required.
What does LOW.rEF mean on OHAUS Touch Panel?
If the OHAUS Touch Panel displays 'LOW.rEF', it's a warning that the average piece weight of the parts is small. Use parts with an average piece weight greater than or equal to 1 division.
What does REF.WT Err mean on OHAUS Touch Panel?
If the OHAUS Touch Panel displays 'REF.WT Err', it indicates that the average piece weight of the parts is too small. Use parts with an average piece weight greater than or equal to 0.1 division.
What does error 8.2 mean on OHAUS Touch Panel?
If the OHAUS Touch Panel displays 'Error 8.2', it indicates the weight reading is below the Power On Zero limit. To correct this, add a load to the scale and then recalibrate.
What does Error 8.4 mean on OHAUS Touch Panel and how to resolve it?
If the OHAUS Touch Panel displays 'Error 8.4', it means the weight reading is below the Underload limit. To resolve this, add load to the scale and then recalibrate it.
General| Display | LCD with backlight |
|---|---|
| Calibration | External Calibration |
| Series | 3000 |
| Manufacturer | OHAUS |
| Readability | 0.1g |
| Power | AC Adapter |
| Connectivity | RS232 |
| Operating Temperature | 10°C – 40°C |
| Pan Size | 120 mm - 170 mm |
