What to do if OHAUS Scales cannot turn on?
If your OHAUS Scales won't turn on, the issue might be due to no power reaching the scale or incorrectly installed batteries. Check the AC adapter connections and voltage. If using batteries, replace them, ensuring correct polarity.
Why OHAUS Traveler cannot calibrate?
If OHAUS Scales fail to calibrate, the reasons could be an unstable environment, incorrect calibration mass, the Transportation Lock being set, or the Calibration Lock switch being set. Move the scale to a more stable location. Ensure you're using the correct calibration masses. Slide the Transportation Lock pin and the Calibration Lock switch to their unlocked positions.
What to do if OHAUS Traveler Scales show Err 2?
If OHAUS Scales display Err 2, it indicates an overload or underload condition, the Transportation Lock is set, or improper calibration. Ensure the pan is installed correctly and remove any excess load. Also, slide the Transportation Lock pin to the unlocked position. Finally, perform calibration.
Why OHAUS Scales have poor accuracy?
Poor accuracy in OHAUS Scales can stem from several causes: improper calibration, an unstable environment, the Transportation Lock being set, debris touching the pan, or the draft shield touching the pan or sample. Calibrate the scale, move it to a stable location, unlock the Transportation Lock, clean any debris, and ensure the pan is correctly seated and the sample height is appropriate.
What does it mean if OHAUS Traveler Scales display (Flashing)?
If the display on your OHAUS Scales is flashing, it indicates that the battery power is low. Replace the batteries soon.
What does Err 4 mean on OHAUS Traveler Scales?
If OHAUS Scales show Err 4, it means an invalid calibration mass is being used. Verify that the correct calibration mass is being used.
What does bAtt LowW mean on OHAUS Traveler?
If OHAUS Scales display 'bAtt LowW', it signifies that the battery power is too low for proper operation. Replace the batteries.
What does Err 8 mean on OHAUS Scales?
If OHAUS Scales display Err 8, it indicates that the RS232 buffer is full. Try cycling the scale off and on. If the RS232 option is installed, check the RS232 settings on both the scale and the computer.
What does Err 1 mean on OHAUS Traveler?
If OHAUS Scales display Err 1, it indicates invalid Checksum data. Cycle the scale off and on.
Essential safety guidelines for using the Traveler Scales, covering power, environment, and handling.
Identifies and explains the function of each button on the Traveler Scales.
Instructions for releasing transport locks and installing the scale's pan.
Step-by-step process for performing the initial calibration of the scale.
A guide to identifying and resolving common problems with the scale.
A table detailing the technical specifications of the Traveler Scales models.
General| Readability | 0.1 g |
|---|---|
| Display | LCD |
| Calibration | External |
| Units of Measurement | Grain; Gram; Ounce; Pennyweight |
| Operating Temperature | 10°C to 40°C |
To Next Page