Quick Start Guide Traveler
Scales
Ohaus Corporation www.ohaus.com i Traveler
Scales Quick Start Guide
PREPARATION FOR USE
Install Pan, Release Locks
Install the metal pan over the sub-platform.
Before using the scale, release the
Transportation Lock. On scale bottom,
slide the locking pin to the position.
Calibration Lock: to change, see Instruction
Manual. (Otherwise leave as is.)
Check Power
Be sure local line voltage matches voltage
printed on the scale’s power adapter. If not,
contact an Ohaus dealer.
To use battery power, remove battery cover
and insert LR6 (AA) batteries.
SELECTING THE LOCATION:
Place on a firm, steady surface. Avoid locations with excessive air current, vibrations,
heat sources, or rapid temperature changes. Place with sufficient space on all sides.
SAFETY PRECAUTIONS
For safe and dependable operation of this product, please comply with the following
safety precautions:
• Verify that the input voltage printed on the power Adapter and the plug type matches
the local power supply.
• Make sure that the power cord does not pose an obstacle or tripping hazard.
• Disconnect the product from the power supply when cleaning.
• Do not operate this product in hazardous or unstable environments.
• Do not drop loads on the pan.
• Use only approved accessories and peripherals, as available.
• Operate the product only under ambient conditions specified in the Instruction Manual.
• Service should be performed by authorized personnel only.
Transportation
Lock
Power Input Jack
Remove
Battery
Cover to
insert
Batteries:
LR6 (AA).
Calibration
Lock
Communication
Interface
compartment
(See page 3.)
Quick_Start_Guide_Traveler_V1
To Next Page
Need help?
General
