To Next PageTo Next Page
Need help?Do you have a question about the ohmex SONARMITE and is the answer not in the manual?
General| Category | Marine Equipment |
|---|---|
| Frequency | 200 kHz |
| Beam Width | 12° |
| Minimum Range | 0.5 m |
| Housing Material | Plastic |
| IP Rating | IP68 |
| Operating Temperature | -10°C to +50°C |
| Cable Length | 10 m |
Digital components synthesizing frequencies, using DSP, encapsulated in resin, cable carries low DC voltage.
Connect transducer to Txr, LED next to Bluetooth antenna turns on.
Varies with temperature, salinity, turbidity; affects depth calculation accuracy.
BTX has NiMH battery; avoid running flat; charger indicators.
Read instructions, charge only NiMH/NiCd, check manufacturer, correct polarity, avoid heat.
Charger for 3-10 cells, auto detects cells, charging indicators.
Consider proximity to metacentre, turbulence from propellers, hull deadrise.
PIN is '1234' for BTX/SPX devices.
Compatible with SPP, features include range, integration, small footprint.
Settings for character echo, line delays, and ASCII receiving format.
Baud rate, data bits, parity, stop bits, and flow control settings.
6-way female connector for PC serial connection or polled mode.
Details on TXR and PC connector pins and functions.
Solid blue for connected, solid red for low power, flash for faults/data.
Uses single character commands via Bluetooth for parameter setting.
Configuration data copied to RAM; commands change active states.
Commands for reset, load, and save settings to flash memory.
Displays current output formats like Old SonarMite, NMEA, Polled, System.
Toggles between various output formats including Old SonarMite and New SonarMite.
