Print media > 11
5. Load the sheet to be printed, top edge first, print side up,
into the feeder and push it gently until you feel slight
resistance. The printer will advance the paper a short
distance and retain it and the Load Paper light will stop
flashing.
When the page image has been processed the paper will be
drawn into the printer and your printed page will be ejected
into the output tray.
T
RANSPARENCIES
AND
LABELS
Choose transparencies designed for use in plain paper
monochrome copiers, as they are required to withstand high
temperature and pressure. These usually have a print side which
feels slightly rougher (matt finish) than the back, which is a little
more glossy.
Transparencies tend to feed more reliably in the manual feeder
than when stacked in the input tray.
Choose sheets of labels designed for use in laser type printers or
copiers. The labels should cover the entire sheet, leaving no part
of the backing sheet exposed, otherwise they will tend to peel off
inside the printer.
L
OADING
TRANSPARENCIES
AND
LABELS
It is recommended to use the manual feeder for this type of
media, as described earlier for paper.
NOTE
Pages are ejected face up. For multipage documents you may
want to choose reverse print order in your print dialogue if
your application offers it.
CAUTION!
Do not use transparencies designed only for hand
marking on an overhead projector. These will melt
inside the printer and cause serious damage.
To Next Page
Loading...
Need help?
Performance
Memory
Paper Handling
Power Consumption
Weight and Dimensions
